Regulatory costs jump 40% in five years driving up housing costs

WASHINGTON – A new study by the National Association of Home Builders (NAHB) finds that regulations at the federal, state and local levels add $131,734 to the cost of a new single-family home—26.4% of the average sales price of $499,500 as of January 2026.

Breaking down the total regulatory costs further, the study revealed that $84,939 of the final house price is the result of costs incurred by the builder due to regulation during the construction phase of the home while $46,795 is attributable to regulation during land development.

“This study illustrates how excessive regulation is deepening the nation’s housing affordability crisis and making it harder for builders to deliver the affordable, attainable housing that our nation sorely needs,” said NAHB Chairman Bill Owens, a home builder and remodeler from Worthington, Ohio. “Policymakers should remove unnecessary and costly regulations that are pricing buyers out of the market and slowing construction of new homes and apartments.”

Although the share of regulation in the land development phase fell from 10.5% in 2021 to 9.4% in 2026, the construction phase increased by nearly four percentage points, rising from 13.3% to 17.0%, largely because of higher building permit fees and changes to building codes over the past decade. Based on U.S. Census home price data, regulatory costs for the average new home increased from $93,870 in 2021 to $131,734 in 2026—an increase of more than 40% in about five years.

Over the same period, U.S. disposable income rose just 18.3%, meaning that regulatory costs are increasing more than twice as fast as consumers’ ability to pay.


 

.

Have something to say? Share your thoughts with us in the comments below.

Profile picture for user larryadams
About the author
Larry Adams | Editor

Larry Adams is a Chicago-based writer and editor who writes about how things get done. A former wire service and community newspaper reporter, Larry is an award-winning writer with more than three decades of experience. In addition to writing about woodworking, he has covered science, metrology, metalworking, industrial design, quality control, imaging, Swiss and micromanufacturing . He was previously a Tabbie Award winner for his coverage of nano-based coatings technology for the automotive industry. Larry volunteers for the historic preservation group, the Kalo Foundation/Ianelli Studios, and the science-based group, Chicago Council on Science and Technology (C2ST).